DJI Mavic 3 Classic User Manual
56
©
2022 DJI All Rights Reserved.
DJI RC-N1
Built into the remote controller is DJI's long-range tranmission technology, offering a maximum
transmission range of 15 km and displaying video from the aircraft to DJI Fly on a mobile device
at up to 1080p 60fps (depending on mobile device). The aircraft and camera are easy to control
using the onboard buttons and the detachable control sticks make the remote controller easier
to store.
In a wide-open area with no electromagnetic interference, the aircraft uses O3+ to smoothly
transmit video links at up to 1080p 60fps (depending on mobile device). The remote controller
works at both 2.4 GHz and 5.8 GHz, automatically selecting the best transmission channel.
The built-in battery has a capacity of 5200 mAh and energy of 18.72 Wh and a maximum run
time of six hours. The remote controller charges the mobile device with a charging ability of 500
mA@5 V. The remote controller automatically charges Android devices. For iOS devices, first
make sure that charging is enabled in DJI Fly. Charging for iOS devices is disabled by default and
needs to be enabled each time the remote controller is powered on.
• Compliance Version: The remote controller is compliant with local regulations.
• Control Stick Mode: The control stick mode determines the function of each control
stick movement. Three pre-programmed modes (Mode 1, Mode 2, and Mode 3) are
available and custom modes can be configured in DJI Fly. The default mode is Mode 2.
Using the Remote Controller
Charging the Battery
Use a USB-C cable to connect the provided
charger to the USB-C port of the remote
controller. It takes approximately four hours
to fully charge the remote controller.
Powering On/Off
Press the power button once to check
the current battery level. Press and then
press and hold to power on/off the remote
controller. If the battery level is too low,
recharge before use.
Controlling the Gimbal and Camera
Shutter/Record Button: Press once take a
photo or to start or stop recording.
Photo/Video Toggle: Press once to switch
between photo and video mode.
Gimbal Dial: Use to control the tilt of the gimbal.
Gimbal Dial
Shutter/
Record Button
Photo/Video
Toggle
Customizable
Button