DJI Mavic 3 Classic User Manual
64
©
2022 DJI All Rights Reserved.
Safety
Flight Assistance
Obstacle Avoidance
Action
Upward, Forward, Backward, and the Lateral Vision Systems are
enabled after setting Obstacle Avoidance to Bypass or Brake. The
aircraft cannot sense obstacles if Obstacle Avoidance is disabled.
Bybassing Options Select Normal or Nifty mode when using Bypass.
Display Radar Map When enabled, the real-time obstacle detection radar map will be
displayed.
Return to Home: Tap to set Advanced RTH, Auto RTH Altitude (default altitude is 100 m), and
to update the Home Point.
Flight Protection: Tap to set the max altitude and max distance.
Sensors: Tap to view the IMU and compass status and start to calibrate if necessary.
Battery: Tap to view the battery information such as battery cell status, serial number, and
times charged.
Auxiliary LED: Tap to set the auxiliary LED to auto, on, or off. DO NOT turn on the Auxiliary
LED before takeoff.
Aircraft Front Arm LEDs: In auto mode, the aircraft front LEDs will be disabled during
recording to ensure the quality is not affected.
Unlock GEO Zone: Tap to view the information about unlocking GEO zones.
The Find My Drone feature helps to find the location of the aircraft on the ground.
Advanced Safety Settings include the behavior settings of the aircraft when the remote
controller signal is lost, when the propellers can be stopped during flight, downward vision
positioning switch, and the AirSense switch.
Signal Lost The behavior of the aircraft when the remote controller signal is
lost can be set to Return to Home, Descend, and Hover.
Emergency Propeller
Stop
“Emergency Only” indicates that the motors can only be stopped
mid-flight in an emergency situation such as if there is a collision,
a motor has stalled, the aircraft is rolling in the air, or the aircraft
is out of control and is ascending or descending quickly. “Anytime”
indicates that the motors can be stopped mid-flight anytime once
user performs a combination stick command (CSC). Stopping the
motors in mid-flight will cause the aircraft to crash.
AirSense An alert will appear in DJI Fly when a manned aircraft is detected
if AirSense is enabled. Read the disclaimer in the DJI Fly prompt
before using AirSense.