MAVIC 2 ENTERPRISE Advanced
User Manual
30
©
2021 DJI All Rights Reserved.
DJI AirSense
Manned aircraft with an ADS-B transceiver actively broadcast flight information, including their
location, flight path, speed, and altitude. DJI AirSense receives this information from ADS-B
transceivers via an on-board receiver or internet connection. UAVs with DJI AirSense installed can
obtain the position, orientation, and velocity information from the built-in ADS-B transmitter (1090ES
or UAT) of a manned aircraft, calculate the collision risk level in real time, and send the warning to the
user. DJI AirSense then analyzes the potential collision risk by comparing the location of the manned
aircraft and sends timely warning prompts to the user via DJI Pilot.
DJI AirSense provides information about nearby manned aircraft to ensure ight safety. It does not
actively control the drone to avoid incoming aircraft. Always y your aircraft within a visual line of sight
and be cautious at all times. Lower your altitude when you receive warning prompts. Be aware that
DJI AirSense has the following limitations:
1. It can only receive messages sent by manned aircraft with an ADS-B out device installed in
accordance with 1090ES (RTCA DO-260) or UAT (RTCA DO-282). DJI devices cannot receive
related broadcast messages or warning prompts from manned aircraft that are not equipped with
functioning ADS-B out devices.
2. If there is an obstacle or steel structure between a manned aircraft and DJI aircraft, DJI AirSense
will not be able to receive ADS-B messages sent by the manned aircraft or send warning prompts
to the user. Pay close attention to your surroundings and y with caution.
3. Warning prompts may be delayed if DJI AirSense experiences any interference from the
surrounding environment. Closely observe the surrounding environment and y with caution.
4. Warning prompts may not be received if the DJI aircraft is unable to determine its location.
5. If disabled or misconfigured, DJI AirSense cannot receive ADS-B messages sent by manned
aircraft or send warning prompts to the user.
When DJI AirSense detects the possibility of a collision, it sends a series of warning prompts based
on the distance between the manned aircraft and the DJI aircraft (when the connection between
the DJI aircraft and the remote controller is stable). After receiving the first warning prompt it is
recommended to immediately descend or choose another ight path to avoid a collision.
Warning Escalation:
1. The lowest level warning occurs when a manned aircraft is detected. Up to 10 detected aircraft
can be displayed in DJI Pilot at a time. Pay attention to ensure ight safety.
2. The medium level warning occurs when the DJI aircraft is two km away from a manned aircraft.
Pay attention to avoid any safety hazards.
3. The highest level warning occurs when the DJI aircraft is one km away from a manned aircraft.
Descend or change the ight path immediately to avoid the manned aircraft.
Red: The third level warning
Blue: The rst level warning Yellow: The second level warning
To Next Page
Loading...
