dji Mavic 3M - Post-Flight Checklist; Maintenance Instructions

DJI Mavic 3M User Manual
102
©
2023 DJI All Rights Reserved
.
• The battery firmware is included in the aircraft firmware. Be sure to update all
batteries.
• Make sure that the battery levels of the aircraft and remote controller are higher than
25% before updating.
• Make sure all DJI devices are connected properly to the computer during an update.
• During the update process, it is normal for the gimbal to go limp, the aircraft status
indicators to blink, and the aircraft to reboot. Wait patiently for the update to complete.
• Make sure to keep the aircraft away from people and animals during a firmware
update, system calibration, or parameter configuration.
• For safety, make sure you are using the latest firmware version.
• After the firmware update is completed, the remote controller and the aircraft may
become disconnected. Re-link them if necessary.
Post-Flight Checklist
• Make sure to perform a visual inspection so that the aircraft, remote controller, gimbal
camera, Intelligent Flight Batteries, and propellers are in good condition. Contact DJI
support if any damage is noticed.
• Make sure that the camera lens and vision system sensors are clean.
• Make sure to store aircraft correctly before transporting it.
Maintenance Instructions
To avoid serious injury to children and animals, observe the following rule:
1. Small parts, such as cables and straps, are dangerous if swallowed. Keep all parts out of
reach of children and animals.
2. Store the Intelligent Flight Battery and remote controller in a cool, dry place away from
direct sunlight to ensure the built-in LiPo battery does NOT overheat. Recommended
storage temperature: between 22° and 28° C (71° and 82° F) for storage periods of more
than three months. Never store in environments outside the temperature range of 14°
to 113° F (-10° to 45° C).
3. DO NOT allow the camera to come into contact with or become immersed in water or
other liquids. If it gets wet, wipe dry with a soft, absorbent cloth. Turning on an aircraft
that has fallen in water may cause permanent component damage. DO NOT use
substances containing alcohol, benzene, thinners, or other flammable substances to
clean or maintain the camera. DO NOT store the camera in humid or dusty areas.
4. DO NOT connect this product to any USB interface older than version 3.0. DO NOT
connect this product to any “power USB” or similar devices.
5. Check every aircraft part after any crash or serious impact. If there are any problems or
questions, contact a DJI authorized dealer.