DJI Mavic 3M User Manual
32
©
2023 DJI All Rights Reserved
.
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the
inner or outer bottom corners to start the motors. Once the motors start spinning, release
both sticks simultaneously.
or
Stopping the Motors
When the aircraft is on the ground and the motors are spining, there are two ways to stop
the motors:
Method 1: Push the throttle stick down and hold. The motors will stop after one second.
Method 2: Perform the same CSC used to start the motors and hold. The motors will stop
after two seconds.
or
Stopping the Motors Mid-Flight
Stopping motors mid-flight will cause the aircraft to crash. The motors should only be
stopped mid-flight in an emergency situation, such as if the aircraft is involved in a collision,
a motor has stalled, the aircraft is rolling in the air, or the aircraft is out of control and is
ascending or descending very quickly. To stop the motors mid-flight, perform the same CSC
that was used to start the motors.
Method 1 Method 2
To Next Page
Loading...
