dji Mavic 3M - Flight Test

DJI Mavic 3M User Manual
33
©
2023 DJI All Rights Reserved
.
Flight Test
1. Place the aircraft in an open, flat area with the aircraft rear facing towards you.
2. Power on the remote controller and the aircraft.
3. Launch DJI Pilot 2 and enter the camera view.
4. Wait for the aircraft self-diagnostics to complete. If DJI Pilot 2 does not show any
irregular warning, you can start the motors.
5. Push the throttle stick up slowly to take off.
6. To land, hover over a level surface and gently push the throttle stick down to descend.
7. After landing, push the throttle stick down and hold until the motors stop.
8. Power off the Intelligent Flight Battery before the remote controller.
Make sure to place the aircraft on a flat and steady surface before takeoff. DO NOT
launch the aircraft from your palm or while holding it with your hand.