dji Mavic 3M - FAR Remote ID Compliance Information

DJI Mavic 3 Pro User Manual
109
©
2023 DJI All Rights Reserved.
• When the aircraft and DJI Fly app cannot obtain a GPS signal, the GEO awareness
function will be inoperative. Interference of the aircraft antenna or disabling the GPS
authorization in DJI Fly will cause the GPS signal fails to be obtained.
EASA Notice
Make sure to read the Drone Information Notices document included in the package before
use.
Visit the link below for more EASA notice information on traceability.
https://www.easa.europa.eu/en/document-library/general-publications/drones-information-
notices
Original Instructions
This manual is provided by SZ DJI Technology, Inc., and the content is subject to change.
Address: Lobby of T2, DJI Sky City, No. 53 Xianyuan Road, Xili Community, Xili Street, Nanshan
District, Shenzhen, China, 518055.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
• The aircraft automatically initiates a pre-flight self-test (PFST) of the Remote ID system before
takeoff and cannot take off if it does not pass the PFST
[1]
. The results of the PFST of the
Remote ID system can be viewed in a DJI flight control app such as DJI Pilot.
• The aircraft monitors the Remote ID system functionality from pre-flight to shut down. If
the Remote ID system malfunctions or has a failure, an alarm will be displayed in a DJI flight
control app such as DJI Pilot.
• The user shall keep the DJI flight app running in the foreground and always allow it to obtain
the location information of the remote controller.
• Developers who develop third-party applications based on the DJI Mobile SDK shall obtain and
display the PFST results and the failure status of the Remote ID system during operation by
calling specific APIs
[2]
.
Footnotes
[1]
The pass criterion for PFST is that the hardware and software of the Remote ID required-data source
and transmitter radio in the Remote ID system are functioning properly.
[2]
For detailed APIs information, please visit https://developer.dji.com/mobile-sdk/