dji Mavic 3M - Flight Recorder; Propellers

DJI Mavic 3M User Manual
37
©
2023 DJI All Rights Reserved
.
Auxiliary Light
The auxiliary bottom light located at the bottom of the aircraft can assist the downward
vision system. It will automatically turn on by default in low-light environments when the
flight altitude is under 5 m. Users can also turn it on or off manually in the DJI Pilot 2 app.
Each time the aircraft is restarted, the auxiliary bottom light will revert back to the default
setting Auto.
• In low-light environments, the vision systems may not achieve optimal positioning
performance even if the auxiliary bottom light is turned on. Fly with caution if the GNSS
signal is weak in such environments.
• The auxiliary LED is set to auto when used in the EU and cannot be changed. The
aircraft Front Arm LEDs are always on when used in the EU and cannot be changed.
Flight Recorder
Flight data, including flight telemetry, aircraft status information, and other parameters, are
automatically saved to the internal data recorder of the aircraft. The data can be accessed
using DJI Assistant 2.
Propellers
There are two types of DJI Mavic 3M Quick-Release Propellers designed to spin in different
directions. Marks are used to indicate which propellers should be attached to which motors.
Make sure to match the propeller and motor following the instructions.
Low-Noise Propellers (Model: 8658F) must be used in countries and regions with C2
certification.
Attaching the Propellers
Attach the propellers with marks to the motors with marks and the unmarked propellers
to the motors without marks. Hold the motor, press the propeller down, and rotate in the
direction marked on the propeller until it pops up and locks in place.
Auxiliary Light