dji Mavic 3M - Page 40

DJI Mavic 3M User Manual
40
©
2023 DJI All Rights Reserved
.
Using the Battery
Checking the Battery Level
Press the power button once to check the battery level.
LED1
LED2
LED3
LED4
Power Button
The battery level LEDs display the power level of the battery during charging and
discharging. The statuses of the LEDs are defined below:
LED is on. LED is blinking. LED is off.
LED1 LED2 LED3 LED4 Battery Level
89%-100%
76%-88%
64%-75%
51%-63%
39%-50%
26%-38%
14%-25%
1%-13%
Powering On/Off
Press the power button once, then press again, and hold for two seconds to power the
battery on or off. The battery level LEDs display the battery level when the aircraft is
powered on.
Low-Temperature Notice
1. Battery capacity is significantly reduced when flying at low temperatures from -10° to 5° C
(14° to 41° F). It is recommended to hover the aircraft in place for a while to heat the
battery. Make sure to charge the battery fully before takeoff.
2. Batteries cannot be used in extremely low-temperature environments of lower than -10° C
(14° F).
3. When in low-temperature environments, end the flight as soon as DJI Pilot 2 displays the
low battery level warning.