dji Mavic 3M - Page 66

DJI Mavic 3M User Manual
66
©
2023 DJI All Rights Reserved
.
Top Bar
1 2 3 4 5 6 7 8
1. Back: tap to return to the home screen of the DJI Pilot 2 app.
2. System Status Bar: indicates the aircraft flight status and displays various warning
messages. If an alert appears during flight, it will be displayed in the system status bar
and continue flashing. Tap to view the message, and the flashing will stop.
3. Flight Status:
a. The flight statuses include: standby, preparing to take off, ready to go, manual flight,
mission flight, pano in progress, landing, vision positioning, etc.
b. When the aircraft is in vision positioning, standby, or manual flight status, the
current flight mode will be displayed, including N, S, A, and T modes.
c. Tap to enter the Preflight Check view.
4. Battery Level Indicator Bar: displays the battery level and the remaining flight time of
the Intelligent Flight Battery after takeoff. Different battery levels are represented by
different colors. When the battery level is lower than the warning threshold, the battery
icon turns red, reminding the user to land the aircraft as soon as possible and replace
the batteries.
5. GNSS Positioning Status: displays the number of searched satellites. RTK is only
displayed after the RTK module is installed. When the RTK service is not enabled, the
RTK icon is gray. When the RTK data is converged, the RTK icon will turn white. Tap the
GNSS positioning status icon to view the RTK mode and GNSS positioning information.
6. Signal Strength: includes the video and control signal quality. Three white dots indicate
strong signals, two yellow dots for medium signal strength, and one red dot for poor
signal quality. If the signal is lost, it displays a disconnected icon in red.
7. Intelligent Flight Battery Level: displays the battery level of the aircraft. Tap to view
battery level, voltage, and temperature.
8. Settings: tap to open the Settings menu to set the parameters of each module.
a.
Flight Control System Settings: includes flight mode switch, Home Point, RTH
altitude, maximum altitude, maximum flight distance, sensor status, out-of-control
action, coordinated turn, GNSS, and Find My Drone.
b.
Sensing System Settings: includes obstacle sensing switch, vision positioning
switch, and precision landing switch.
c.
Remote Controller Settings: includes stick mode, customizable button settings,
and remote controller calibration and linking.
d.
Video Transmission Settings: includes work frequency, channel mode, and video
output type.