To Next Page

To Previous Page

ZENMUSE X7

User Manual

Installing a Camera Lens

Required Lens Accessories

The Zenmuse X7 DL-mount supports the DJI DL/DL-S Lens series. Gimbal performance is aect-

ed by the weight of the camera. The balancing ring, lens hood, and lens protector are included

on all DJI DL/DL-S Lenses.

DJI oers the DL/DL-S Lens Filter Set (DLX series) which are compatible with the DL/DL-S lens

series. Please visit the DJI online shop to purchase based on your specic needs.

Specications of the DL/DL-S Lens lters and protector (DLX series) are shown as below:

Filter/Protector (DLX Series) Diameter Weight

DJI DL/DL-S ND4 Filter 46 mm Approx. 9 g

DJI DL/DL-S ND8 Filter 46 mm Approx. 9 g

DJI DL/DL-S ND16 Filter 46 mm Approx. 9 g

DJI DL/DL-S ND32 Filter 46 mm Approx. 9 g

DJI DL/DL-S ND64 Filter 46 mm Approx. 9 g

DJI DL/DL-S ND128 Filter 46 mm Approx. 9 g

DJI DL/DL-S Lens Protector 46 mm Approx. 9 g

1. The lens protector is used to protect the lens during transportation, storage, and use. We rec-

ommend using it in severe shooting environments to prolong the service life of the lens. Please

be aware that there might be lens are in some situations when the protector is in use.

2. Non-ocial lters are supported for both DL/DL-S lenses. Please use a lter with a diameter

of 46 mm and a thickness of 4.4 mm (thread mount excluded). The total weight of the lters,

protectors, balancing rings, and lens hood should not exceed 35 g. The following combination

is recommended when mounting the lens onto the Zenmuse X7:

A. Lens hood + lens protector

B. Lens hood + balancing ring

C. Lens hood + ND lter

D. Two ND lters*

Please note that the total weight of the combination mentioned above should be between 10

to 35 g. You may also choose not to attach any balancing ring or lter (lens protector) to the

lens when using the Zenmuse X7, but always attach the lens hood under this situation. The

gimbal is capable of working normally when the total weight of the attached is between 10 to

35 g. An unbalanced gimbal may lead to video jittering, however. It is recommended to keep

the total weight of the attached around 20 g when the gimbal is balancing to ensure optimal

video recording performance.

Jump to page 11 to see how to Mounting Filters/Protector.

* Any two of the DL/DL-S lens lters can be used together, reducing the amount of light coming into the sensor

to achieve the desired exposure eect. When attaching two lters, make sure to detach the lens hood. Howev-

er, the capacity for are reduction may reduce the without a lens hood.

dji ZENMUSE X7 User Manual

Other manuals for dji ZENMUSE X7