DNP DP-DS620 - Page 19

16
Dai Nippon Printing Co., Ltd.
[DP-DS620/DP-DS620 (A) Printer Driver] User’s Manual (For Windows 7, 8)
Advanced Printing Features
Always set Enable. Do not use other settings.
Pages per Sheet Layout
Set the layout direction of an image when the Pages per Sheet setting is set for multiple divisions.
Border
Synchronized with Border in the Option.
Overcoat Finish
Set the overcoat finish method for the surface of printed items from the following two types.
Overcoat Finish
Function
Glossy
Create an item with a glossy finish.
Matte
Create an item with a matte finish.
Print Re-try
Specify whether to print data in the printer buffer after a printer error has been cleared.
Print Re-try
Function
Disable
Clear the print data in the printer buffer when a printer error occurs.
You must send the cleared print data again after the error is cleared.
When you use an application with an error recovery function, select this option.
Enable
Save print data in the printer buffer when an error occurs.
The printing process is restarted from the saved data after the error is cleared.
Note that if the power is switched off, the data is not saved.
Depending on the content of the printer error, it may be necessary to restart the printer to clear the error. In such
cases, the print data in the printer buffer is cleared regardless of the Print Re-try setting.
The following section shows the operation for each Print Re-try setting by error.
Error content
When Print Re-try is disabled
When Print Re-try is enabled
Paper end
You must send the unprinted image data
again after the error is cleared.
The printing process is restarted from the
data saved in the printer buffer after the error
is cleared.
When the paper initialization operation is to
be carried out, printing occurs afterwards.
Ribbon end
Cover open
Paper jam (*1)
Ribbon error (*1)
Paper setting error
Data error
Because the printer must be switched on
and off to clear the error, the print data in the
printer buffer is cleared regardless of the
Print Re-try setting.
After the printer has restarted, you must
send the unprinted image data again.
Because the printer must be switched on
and off to clear the error, the print data in the
printer buffer is cleared by switching the
printer off, even when the Print Re-try setting
is Enabled.
After the printer has restarted, you must
send the unprinted image data again.
Head voltage error
Head position error
Power supply fan stopped
Cutter error
Head temperature error
Media temperature error
RFID module error
System error
*1: After the printer stops due to an error, follow the user’s manual of the printer to eliminate the cause of the paper
or ribbon error.
2inch cut
Specify whether to cut paper into multiple sheets with a 2-inch length when you use a specified paper size.
2inch cut
Function
Disable
Cut at the normal size.
Enable
Cut at 2-inch lengths so that the 6 x 4 size becomes two sheets and the 6 x 8 size
becomes four sheets.