Dockmate SINGLE - Page 61

59
Problem
Possible cause
Solution
Code 2 – 1
Remote “link” LED:
2x followed by 1x
Receiver Status LED:
2x followed by 1x
No communication with thruster
system.
Check if thruster system is on and
operational. Can You control the
thrusters from the thruster control
panel on the dashboard?
Code 2 – 2
Remote “link” LED:
2x followed by 2x
Receiver Status LED:
2x followed by 2x
No communication with engine /
motor system.
Check if engine system is on and
operational.
Code 2 – 3
Remote “link” LED:
2x followed by 3x
Receiver Status LED:
2x followed by 3x
No communication with Thruster
Interface.
Turn your Dockmate Receiver off
and on again. If the error persists,
contact Your Dockmate dealer.