Dockmate SINGLE - Page 62

60
Problem
Possible cause
Solution
Code 2 – 4
Remote “link” LED:
2x followed by 4x
Receiver Status LED:
2x followed by 4x
No communication with Engine
Interface.
Check if the ignition is on.
Turn your Dockmate Receiver off
and on again. If the error persists,
contact Your Dockmate dealer.
Code 3 – 1
Remote “link” LED:
3x followed by 1x
Receiver Status LED:
3x followed by 1x
Power Supply Fail:
Power supply to the Receiver
is too low.
Check the boat’s battery voltage
and connection. Dockmate
requires a minimum of 11.0V
Code 3 – 2
Remote “link” LED:
3x followed by 2x
Receiver Status LED:
3x followed by 2x
Internal Error:
Internal settings memory
corrupted.
Call your Dockmate technician to
setup all necessary settings.