Dodge CHALLENGER 2023 - Power Mirrors; Heated Mirrors - if Equipped; Universal Garage Door Opener (Homelink); Before You Begin Programming Homelink

POWER MIRRORS
The power mirror switch is located on the driver's side
door trim panel.
The power mirror controls consist of mirror select but-
tons and a four-way mirror control switch. To adjust a
mirror, push the mirror select button for the mirror that
you want to adjust. Using the mirror control switch,
push on any of the four arrows for the direction that you
want the mirror to move.
NOTE:
A light in the select button will illuminate indicating the
mirror is activated and can be adjusted.
HEATED MIRRORS — IF EQUIPPED
These mirrors are heated to melt frost or ice.
This feature will be activated whenever you
turn on the rear window defroster
(if equipped)
page 42.
UNIVERSAL GARAGE DOOR OPENER
(HOMELINK®)
Use this QR code to access your digital
experience.
•
HomeLink® replaces up to three
hand-held transmitters that operate
devices such as garage door open-
ers, motorized gates, lighting, or
home security systems. The HomeLink® unit is pow-
ered by your vehicle’s 12 Volt battery.
•
The HomeLink® buttons that are located in the
overhead console or sunvisor designate the three
different HomeLink® channels.
•
To operate HomeLink®, push and release any of the
programmed HomeLink® buttons. These buttons
will activate the devices they are programmed to
with each press of the corresponding HomeLink®
button.
•
The HomeLink® indicator light is located above the
center button.
NOTE:
HomeLink® is disabled when the Vehicle Security sys-
tem is active
page 243.
BEFORE YOU BEGIN
PROGRAMMING HOMELINK®
For efficient programming and accurate transmission of
the Radio Frequency (RF) signal, it is recommended
that a new battery be placed in the hand-held transmit-
ter of the device that is being programmed to the
HomeLink® system. Make sure your hand-held trans-
mitter is programmed to activate the device you are
trying to program your HomeLink® button to.
Ensure that your vehicle is parked outside of the garage
before you begin programming.
It is recommended that you erase all the channels of
your HomeLink® before you use it for the first time.
Power Mirror Control
1 — Left Mirror Selection
2 — Mirror Adjustment
3 — Right Mirror Selection
HomeLink® Buttons And Indicator Light
Scan me
GETTING TO KNOW YOUR VEHICLE 33
2
5548538-23_LA_OM_EN_USC_t_E2.pdf 33 4/7/2023 2:38:35 PM