STATIONARY OBJECTS AND VEHICLES
ACC does not react to stationary objects or vehicles. For
example, ACC will not react in situations where the
vehicle you are following exits your lane and the vehicle
ahead is stopped in your lane. It will consider this
stopped vehicle a stationary object as it did not previ-
ously detect movement from it. Always be attentive and
ready to apply the brakes if necessary.
PARKSENSE REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Rear Park Assist system provides visual
and audible indications of the distance between the
rear fascia/bumper and a detected obstacle when
backing up (e.g. during a parking maneuver).
For limitations of this system and recommendations,
see
page 86.
ParkSense will retain the last system state (enabled or
disabled) from the previous ignition cycle when the igni-
tion is changed to the ON/RUN position.
ParkSense can be active only when the gear selector is
in REVERSE. If ParkSense is enabled at this gear selec-
tor position, the system will remain active until the
vehicle speed is increased to approximately 7 mph
(11 km/h) or above. The system will become active
again if the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).
PARKSENSE SENSORS
The four ParkSense sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location, type
and orientation of the obstacle.
PARKSENSE DISPLAY
When the vehicle is in REVERSE, the warning display
will turn on indicating the system status.
The system will indicate a detected obstacle by showing
a single arc in one or more regions based on the obsta-
cle’s distance and location relative to the vehicle.
If an obstacle is detected in the center rear region, the
display will show a single solid arc in the center rear
region and will produce a one-half second tone. As the
vehicle moves closer to the obstacle, the display will
show the single arc moving closer to the vehicle and the
sound tone will change from slow, to fast, to
continuous.
If an obstacle is detected in the left and/or right rear
region, the display will show a single flashing arc in the
left and/or right rear region and will produce a fast
sound tone. As the vehicle moves closer to the
obstacle, the display will show the single arc moving
closer to the vehicle and the sound tone will change
from fast to continuous.
Narrow Vehicle Example
Stationary Object And Stationary Vehicle Example
STARTING AND OPERATING 83
4
5548538-23_LA_OM_EN_USC_t_E2.pdf 83 4/7/2023 2:38:36 PM
To Next Page
Loading...
