The vehicle is close to the obstacle when the warning display shows one flashing arc and sounds a continuous tone. The following chart shows the warning alert operation when
the system is detecting an obstacle:
WARNING ALERTS
Rear Distance
(inches/cm)
Greater than
79 inches (200 cm)
79-59 inches
(200-150 cm)
59-47 inches
(150-120 cm)
47-39 inches
(120-100 cm)
39-25 inches
(100-65 cm)
25-12 inches
(65-30 cm)
Less than
12 inches (30 cm)
Audible Alert
Chime
None
Single 1/2
Second Tone
(for rear center
only)
Slow
(for rear center
only)
Slow
(for rear center
only)
Fast
(for rear center
only)
Fast Continuous
Arc — Left Rear None None None None None 2nd Flashing 1st Flashing
Arc — Center Rear None 6th Solid 5th Solid 4th Solid 3rd Flashing 2nd Flashing 1st Flashing
Arc — Right Rear None None None None None 2nd Flashing 1st Flashing
Radio Volume
Reduced
No Yes Yes Yes Yes Yes Yes
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen will only be displayed if
Sound and Display is selected from within the Uconnect
system
page 95.
The ParkSense Warning screen is located within the
instrument cluster display. It provides visual warnings to
indicate the distance between the rear fascia/bumper
and the detected obstacle.
ENABLING AND DISABLING
PARKSENSE
ParkSense can be enabled and disabled
with the ParkSense switch, located on the
switch panel below the Uconnect display.
When the ParkSense switch is pushed to disable the
system, the instrument cluster will display the
“ParkSense Off” message for approximately five sec-
onds. When the gear selector is moved to REVERSE and
the system is disabled, the instrument cluster display
will display the “ParkSense Off” message for as long as
the vehicle is in REVERSE.
The ParkSense switch LED will be on when ParkSense
is disabled or requires service. The ParkSense switch
LED will be off when the system is enabled. If the
ParkSense switch is pushed, and the system requires
service, the ParkSense switch LED will blink momentar-
ily, and then the LED will be on.
SERVICE THE PARKSENSE REAR
PARK ASSIST SYSTEM
During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle and it will display the “PARKSENSE
UNAVAILABLE WIPE REAR SENSORS” or “PARKSENSE
UNAVAILABLE SERVICE REQUIRED” message for five
seconds.
When the gear selector is moved to REVERSE and the
system has detected a faulted condition, the instru-
ment cluster display will display the “PARKSENSE
UNAVAILABLE WIPE REAR SENSORS” or “PARKSENSE
UNAVAILABLE SERVICE REQUIRED” message for as long
as the vehicle is in REVERSE. Under this condition,
ParkSense will not operate.
STARTING AND OPERATING 85
4
5548538-23_LA_OM_EN_USC_t_E2.pdf 85 4/7/2023 2:38:36 PM
To Next Page
Loading...
