ENGINE
When selected, this screen displays the following val-
ues:
•
Vehicle Speed
Shows the actual vehicle speed.
•
Engine Power
Shows the instantaneous power.
•
Engine Torque
Shows the instantaneous torque.
•
Oil Pressure (6.4L Only) — If Equipped
Shows the actual engine oil pressure.
•
Boost Pressure (6.2L Only) — If Equipped
Shows the actual boost pressure.
•
Gear (Automatic Transmission Only)
Shows the current (or pending) operating gear of the
vehicle.
DYNAMOMETER (DYNO)
The system will start drawing graphs for Power and
Torque (top chart) and Engine Speed (bottom chart).
The graph will fill to the right side of the page (based on
History time selected). Once the right side of the page
is reached, the graph will scroll with the right side
always being the most recent recorded sample.
The following options can be selected:
•
Pressing the STOP button will freeze the graph.
Selecting Play will clear the graph and restart the
process over.
•
Press the + or - buttons to change the history of the
graph. The selectable options are “30”, “60”, “90”,
and “120” seconds. The graph will expand or con-
strict depending on the setting selected.
•
Select the “Gear” display setting to turn the graph
gear markers on and off for automatic transmission
vehicles only.
NOTE:
The Gear on/off feature will only display if your vehicle
is equipped with an Automatic Transmission.
DODGE DRIVE MODES — IF EQUIPPED
PERFORMANCE CONTROL —
IF EQUIPPED
Your vehicle may be equipped with a Performance Con-
trol feature which allows for coordinating the operation
of various vehicle systems depending upon the type of
driving behavior desired. The Performance Control fea-
ture is controlled through the Uconnect system and may
be accessed by performing any of the following:
•
Pushing the Super Track Pack button on the instru-
ment panel switch bank.
•
Selecting “Performance Control” from the Apps
menu.
•
Selecting “Performance Control” from within the
Performance Pages menu.
You will be able to enable, disable, and customize the
functionality of the Launch Control and Performance
Control Set-Up features within Performance Control.
To access information about the functionality of these
features through the Uconnect system, press the Info
button on the touchscreen.
NOTE:
Dodge vehicles equipped with a 6.4L engine, except for
R/T Scat Pack 1320 6.4L non-widebody vehicles, will
use SRT Drive Modes rather than the Dodge Perfor-
mance Control Pages. Please refer to the following sec-
tions for further information on the SRT Drive Modes.
Performance Pages — Engine Performance Pages — Dyno
134 MULTIMEDIA
5548538-23_LA_OM_EN_USC_t_E2.pdf 134 4/7/2023 2:38:38 PM
To Next Page
Loading...
