Front Defrost Button
Press and release the Front Defrost button
on the touchscreen, or push and release the
button on the faceplate, to change the cur-
rent airflow setting to Defrost mode. The
Front Defrost indicator illuminates when Front Defrost is
on. Air comes from the windshield and side window
demist outlets. When the defrost button is selected, the
blower level may increase. Use Defrost mode with maxi-
mum temperature settings for best windshield and side
window defrosting and defogging. When toggling the
front defrost mode button, the climate system will
return to the previous setting.
Rear Defrost Button
Press and release the Rear Defrost button
on the touchscreen, or push and release the
button on the faceplate, to turn on the rear
window defroster and the heated outside
mirrors (if equipped). The Rear Defrost indicator illumi-
nates when the rear window defroster is on. The rear
window defroster automatically turns off after
10 minutes.
CAUTION!
Failure to follow these cautions can cause damage to
the heating elements:
•
Use care when washing the inside of the rear win-
dow. Do not use abrasive window cleaners on the
interior surface of the window. Use a soft cloth and
a mild washing solution, wiping parallel to the
heating elements. Labels can be peeled off after
soaking with warm water.
(Continued)
CAUTION!
•
Do not use scrapers, sharp instruments, or abra-
sive window cleaners on the interior surface of the
window.
•
Keep all objects a safe distance from the window.
Driver And Passenger Up And Down
Buttons
These buttons provide the driver and passenger with
independent temperature control.
Push the red button on the faceplate or touch-
screen or press and slide the temperature bar
towards the red arrow button on the touch-
screen for warmer temperature settings.
Push the blue button on the faceplate or
touchscreen or press and slide the tempera-
ture bar towards the blue arrow on the
touchscreen for cooler temperature settings.
SYNC Button
Press the SYNC button on the touchscreen
to toggle the Sync feature on/off. The SYNC
indicator is illuminated when SYNC is on.
SYNC is used to synchronize the passenger
temperature setting with the driver temperature setting.
Changing the passenger temperature setting while in
SYNC will automatically exit this feature.
NOTE:
The SYNC button is only available on the touchscreen.
Blower Control
Blower Control is used to regulate the
amount of air forced through the Climate
Control system. There are seven blower
speeds available. Adjusting the blower will
cause automatic mode to switch to manual operation.
The speeds can be selected using either the blower
control knob on the faceplate or the buttons on the
touchscreen.
Faceplate
The blower speed increases as you turn the blower con-
trol knob clockwise from the lowest blower setting. The
blower speed decreases as you turn the blower control
knob counterclockwise.
Touchscreen
Use the small blower icon to reduce the blower setting
and the large blower icon to increase the blower set-
ting. Blower can also be selected by pressing the blower
bar area between the icons.
Mode Control
Change the airflow distribution mode by pressing
one of the Mode buttons on the touchscreen.
The airflow distribution mode can be adjusted so
air comes from the instrument panel outlets,
floor outlets, defrost outlets and demist outlets.
Panel Mode
Air comes from the outlets in the instrument
panel. Each of these outlets can be individu-
ally adjusted to direct the flow of air. The air
vanes of the center outlets and outboard
outlets can be moved up and down or side to side to
regulate airflow direction. There is a shut-off wheel
located below the air vanes to shut off or adjust the
amount of airflow from these outlets.
GETTING TO KNOW YOUR VEHICLE 43
2
5548538-23_LA_OM_EN_USC_t_E2.pdf 43 4/7/2023 2:38:35 PM
To Next Page
Loading...
