Domino D320i Red User Manual

L025317 Issue 5 July 2014 (17)
LIABILITIES AND WARRANTIES
Warranty and liability rights for personal or material damages are precluded,
if they are caused by one of the following:
• Non-designated use of the laser marking system.
• The use of consumer-electronics (e.g. PDAs or Mobiles) as user
interface for the marking laser systems is not recommended nor
supported.
• Unauthorized installation or configuration of software on the controller.
• Unauthorized execution or configuration of programs on operating
system level. On integration of the laser marking system into a TCP / IP
network the Domino Laser GmbH excludes liability for all damages that
are caused by attacks on the controller (like viruses, worms). The laser
marking systems are built for integration in a secure industry network.
• Improper installation, commissioning, operating, and maintaining of
the laser marking system.
• Operating the equipment with defective safety installations, or
improperly installed or inoperable safety and protective devices.
• Non-compliance with the instructions of the operating manual
regarding transport, storage, installation, commissioning, repairs, or
maintenance of the laser marking system.
• Opening the laser unit.
• Unauthorised structural modifications to the laser marking system.
• Unauthorised modifications of the beam and laser parameters.
• Inadequate monitoring of components. (Refer to PART 5
MAINTENANCE AND FAULT FINDING)
• Disasters, war, and acts of God.

Domino D320i Red Specifications

General

Print Technology	Thermal Transfer
Operating Temperature Range	5°C to 40°C
Ribbon Width	4.33" (110mm)
Ribbon Length	300 m (984 ft)
Connectivity	USB, Ethernet, Serial