32 of 54 PSS5000/CONF/804473/40
PSS 5000 – Hardware Configuration Guide
Selecting the CPU Board and Interface Modules
DSB475 136841 4
4
2
2 Current Loop, 4-wire, 30mA
802976/--
DSB476 137571 4 4 2 Current Loop, 3-wire, 20mA (act.)
803177/--
DSB486 139212 8 1 2 Current Loop, 2-wire, 20mA (pas)
803689/--
DSB492 140042 8 1 2 Current Loop, 2-wire, 45mA (act)
803807/--
DSB501 142012 2
P
2
1 RS485
804407/--
DSB503 142061 1 16 1 Current Loop, 4-wire, 40mA (act.)
804432/--
DSB510 142390 4 1 1 Current Loop, 2-wire, 30mA (act.)
804541/--
DSB511 142464 4 1 1 Current Loop, 2-wire, 45mA (act)
804598/--
DSB517 143186 8 1 2 Current Loop, 2-wire, 20mA (act.)
804897/--
DSB520 143357 4 1 2 Current Loop, 3-wire, 20mA (pas)
804933/--
DSB521 143437 4 1 2 RS485, +5V supply
804979/--
DSB522 143576 12 – 2
LON (TP/FT-10)
3
804998/--
DSB524 143753 2 32 2 Digital I/O
805084/--
DSB541 143753 4 1 2 4-wire, Diff. Interface
805648/--
DSB542 144762 8 1 2 Current Loop, 2-wire, 20mA (act),
RX inverted
805672/--
2
: It is recommended that only 1 device is used on each connection
3
: Only one LON (TP/FT-10) interface can be installed on each system.
P: The maximum number of devices/connection is dependent on the protocol baud rate used
HIM Stock No.
No. of
connectors
Max. no. of
devices/connection
Width
(in module units)
Interface type
Drawings
/<mod.no.>/indr/
To Next Page
Loading...
