DoorKing 1601 - Page 29

1601-065-P-12-19
23
Operator will
lower the arm
ONLY after the
last vehicle
activates
then clears
the down loop.
Operator will
override
multiple
DOWN
commands.
Arm will
remain up
while counting
the vehicles
activating
the down loop.
Operator will count each valid UP command from each vehicle as they enter.
This option allows the access
control device and the barrier gate
operator to have multiple vehicles
in the area between them. The
operator will count all the valid UP
commands received and require a
down loop activation for each one.
The arm will lower only after the
last vehicle activates then clears the
down loop.
Remote transmitters are NOT
recommended for this option
because one vehicle’s remote can
accidently be pressed multiple
times which will get counted by the
operator as multiple vehicles.
Access Control Device
1
1
4
3
5
5
Note:
If a valid UP command is given
while the arm is lowering, the
arm will raise.
Option 2 - Override Multiple DOWN Commands
SW2, Switch 3 ON
Valid UP command given
Operator
will raise
arm
1
2
3
4 5
Basic operator UP/DOWN cycle:
A. Valid UP command from the
access control device will raise arm.
B. Vehicle activating and clearing
the down loop will lower the arm.
NOT A WALKWAY
NOT A WALKWAY
NOT A WALKWAY
NOT A WALKWAY
Down Loop
Down Loop
2
Down Loop
NOT A WALKWAY
NOT A WALKWAY