DoorKing 1601 - Special Lane Configurations; Ticket Spitter Entry Lane Setup

1601-065-P-12-19
16
9411
C
NC
NO
9409
Dual Channel
3.4 Ticket Spitter Entry Lane
REVERSE
SENSITIVITY
TIME
DELAY
POWER
1
ON
2 3 4 5 6 7 8 1
ON
2 3 4 5 6 7 8
NC NO
UP
LOOP
DOWN
LOOP
123456 789 10 11 12 13 14
1601
SW 1
SW 1, switch 4 is ON.
SW 1, switch 7 is OFF (Timer). The arm will rotate
down after the vehicle clears the down loop.
See timer note below.
Speed Bump
Ticket Eject
Loop
Com
NO
Com
NO
Ticket
Spitter
SW 1
SW 2
A
A
Pedestrian Photo Sensor Note: Photo sensor must be installed to protect pedestri-
ans from the lowering arm. When connected as shown, the photo sensor will only
cause an arm reversal when a vehicle is not present on the down loop. When a
vehicle is present on the down loop, the photo sensor has no affect on the barrier
arm operation. A down loop MUST be installed directly under the arm for the
pedestrian photo sensor to function.
Timer Note: The timer can be used with a down loop. When timer is ON with a down
loop, it will start countdown when the arm has fully raised. Activation of the down
loop will cancel timer countdown. Useful when the ticket spitter has been activated
but vehicle does not move forward to activate the down loop. The arm will remain
UP. Timer will time out and lower the arm without the down loop being activated.
Helps increase distance
and time between vehicles.
1
ON
2 3 4 5 6 7 8
Main Terminal
Down Loop
NOT A WALKWAY
NOT A WALKWAY
Pedestrian Photo Sensor
Single Channel
with Aux Relay
Com
Com
Reverse
NC
Jumper
Loop 1
Type of wiring to be used on ALL external devices:
A) Type CL2, CL2P, CL2R, or CL2X.
B) Other cable with equivalent or better electrical,
mechanical, and flammability ratings.