6500-065-J-7-18
17
1.9 Continued
CLOSING Reversing Edge: Obstructed close-direction reversing edge will
Reverse the gate back to the open position. Another input is needed to close
the gate.
OPENING Reversing Edge: Obstructed open-direction reversing edge will
Reverse the gate 2 inches and STOP. Another input is needed to open the
gate.
Close-Direction Reversing Edge
Open-Direction
Reversing Edge
Potential
Entrapment
Area
Opening Gate
Closing Gate
Wall
Wall
Greater than 6” but less than 16”
Reversing Edge
See page 28 for UL
325 terminal wiring
for a reversing edge.
Gate Frame (Closed)
Reversing
Edge
Typical Reversing Edge mounted on end of gate.
Typical Reversing Edge mounted on
bottom of gate when necessary.
If the bottom of gate is greater than 6” but less than
16” above the ground at any point in its arc of
travel, entrapment protection is REQUIRED.
If the distance between an entrapment or obstruction
exists less than 16” from the open gate, then
entrapment protection is REQUIRED for this area.
Entrapment protection
is RECOMMENDED for
this area.
OPTIONAL wireless transmitter can be used.
Receiver MUST monitor for the presence of
the transmitter.
Monitored Edge
Transmitter
OPTIONAL wireless transmitter can be used.
Receiver MUST monitor for the presence of
the transmitter.
Monitored Edge
Transmitter
To Next Page
Loading...
