DoorKing 6500 Series - Gearbox Shaft Extension Replacement

6500-065-J-7-18
39
6.5 Gearbox Shaft Extension Replacement
Hub Extension Shaft Assembly P/N 6500-162
Crank Arm
Magnet
Assy
P/N 6500-420
Snap Ring Channel
Gearbox
P/N 2600-719
P/N 2630-007 Snap Ring
Removing snap ring will release hub extension shaft.
Stainless Steel Washer P/N 2620-075
Limit Sensors Collar P/N 6500-117
Remove the FOUR bolts to remove collar.
Crank Arm Only P/N 6500-255
Control Arm Only P/N 2600-714
Elbow Assy ONLY P/N 2600-720
Complete Arm Kit P/N 6500-430
Brass Bushing P/N 6500-138
Brass Bushings P/N 6500-145
Hub Assembly Remove the TWO bolts to remove
hub assembly from hub extension shaft.
Limit Sensor Assemblies Loosen set
screws on plastic limit assemblies to
remove them. Be CAREFUL not to
damage limit sensor wires after the
assemblies have been removed.
Note: Close Limit Sensor must be
reinstalled on TOP of Open Limit Sensor.
Bushing Lock Plate P/N 6500-123
P
US
H
T
O
O
P
E
RA
T
E
t
e
c
h
ni
ci
a
n
us
e
o
n
l
y
OPEN
CLOSE
Limit Sensors
P/N 6600-032
Close Bracket
P/N 6600-030
Open Bracket
Limit Sensor P/N 1601-261
Limit Sensor P/N 1601-263