OPTIONS
37
7/71, 12/56
LUBRICATOR
SAFETY
WARNING: Ensure that the lubricator filler cap is re−tightened
correctly after replenishing with oil.
WARNING: Do not replenish the lubricator oil, or service the
lubricator without first making sure that the machine is stopped
and the system has been completely relieved of all air pressure
(Refer to STOPPING THE UNIT in the OPERATING
INSTRUCTIONS section of this manual).
CAUTION: If the nylon tubes to the lubricator are disconnected then
ensure that each tube is re−connected in its original location.
GENERAL INFORMATION
Oil capacity: 2 litres
Oil specification:
Refer to the Tool Manufacturer’s Manual.
OPERATING INSTRUCTIONS
COMMISSIONING
Check the lubricator oil level and fill as necessary.
PRIOR TO STARTING
Check the lubricator oil level and replenish as necessary.
MAINTENANCE
Check the lubricator oil level and replenish as necessary.
FAULT FINDING
FAULT CAUSE REMEDY
No oil flow. Incorrect
connection.
Reverse the nylon tube
connections to the lubricator.
To Next Page
Loading...
