A Series Diesel Engine Lubricating System Flow 126
Fill the coolant system and operate the engine to
check for leaks.
Stop the engine and check the coolant and oil level.
Oil Pan, Suction Tube and/or Gaskets
– Replacement
17mm
Drain the oil and remove the pan and gasket.
12mm
Caution : Be sure to connect the support bracket.
If required, remove the suction tube and gasket.
Clean the sealing surfaces.
Install the suction tube and gasket.
Torque Value: 25.5Nm [19 ft-lbs]
Caution : Be sure to fill the joints between the pan
rail, gear housing and rear cover. Use Three
Bond 1207-C.
Clean the pan sealing surfaces.
To Next Page
