A Series Diesel Engine Fuel System 90
Assemble the fuel drain manifold and high pressure
lines.
Leave the high pressure fittings loose at the
injectors.
17mm
Warning : It is necessary to put the engine in the
“run” position: Because the engine may
start, be sure to follow all the safety
precautions. Use the normal engine
starting procedure.
Crank the engine to allow entrapped air to bleed from
the lines. Tighten the fittings.
Electrical Fuel Shut Off Valve –
Replacement
8mm
Remove the electrical wire and complete the
following steps.
Clean around the valve.
To Next Page
Loading...
