Operation Section
-171-
Sideshift Attachment Control
Sideshift Left - Push the knob forward
smoothly to shift the carriage to the left.
Sideshift Hold - Release the sideshift
attachment knob. The knob will return to the
center(hold) position and sideshifting action
will stop.
Sideshift Right - Pull the knob back
smoothly to shift the carriage to the right.
NOTE: To prevent a sudden change of position of
the load, operate all lift, tilt and attachment
knobs smoothly.
Emergency Switch
In case of emergency, push this button. Pushing
button makes the finger tip system on and off
alternately. So if the finger tip control dose not work,
then press this button once.
Warning Lamp
The state of the finger tip system can be checked
by the external warning lamp blinking..
Blinking Lamp State
No Lighting Normal
Lighting E-Stop Condition
Lamp Blinking System Failure
If the warning lamp is blinking, refer to "Diagnosis
LED on finger tip ECU".
To Next Page
Loading...
Need help?
General
