Maintenance Section
-205-
Circuit Breaker
1. Raise the hood and seat assembly. Make sure
the support cylinder securely holds the hood
open.
2. The main circuit breaker is located on the rear
of the support for the hydraulic controls.
NOTE: To reset circuit breakers push in on the
button. The button should stay in if the
breaker is reset. If the button will not stay in,
or comes out shortly after reset, have the
circuits checked.
Battery Terminal - Clean, Inspect
WARNING
Batteries give off flammable fumes that can
explode.
Do not smoke when observing the battery
electrolyte levels.
Electrolyte is an acid and can cause personal
injury if it contacts skin or eyes.
Always wear protective glasses when working
with batteries.
1. Clean the top of the battery and terminals.
2. Check terminals for corrosion. Coat terminals
with heavy grease.
3. Ensure the battery terminal is firmly tightened
and rubber cap is installed.
To Next Page
Loading...
Need help?
General
