Operation Section
-81-
Seat Switch System (If Equipped)
The lift truck is equipped with a SEAT SWITCH
SYSTEM. In normal operation if the direction lever
is placed in either forward or reverse, the lift truck
will move at a speed proportional to the accelerator
pedal's position. If the operator leavers the seat
without setting the parking brake, within three
seconds after leaving the seat, the SEAT SWITCH
SYSTEM will automatically disengage the
transmission. The directional lever, however, will
remain in that forward or reverse location although
internally the transmission will have shifted into
neutral.
Before exiting the lift truck, the parking brake
should always be applied.
WARNING
WHEN LEAVING MACHINE APPLY PARKING
BRAKE!
PARKING BRAKE IS NOT AUTOMATICALLY
APPLIED.
NOTE: Some trucks may be equipped (ask your
dealer if this applies to your truck) with an
alarm that will sound if the parking brake is
not applied when leaving the machine.
NOTICE
Prior to operating the lift truck, be sure to
understand and check the SEAT SWITCH
SYSTEM.
While in normal operation and on level ground,
select a direction with the directional lever and with
the park brake released. You will note that the truck
will move slowly in the selected direction. If you lift
yours hips off of the seat, within three seconds, the
SEAT SWITCH SYSTEM will disengage the
transmission allowing the truck to coast but not
automatically stop.
To restore the lift truck to normal operation, while
sitting in the operator's seat depress the brake
pedal to hold the lift truck, return the directional
lever to the neutral position, and then reselect a
direction of travel (either forward or reverse). The
transmission will then re-engage.
If seat or seat switch replacement becomes
necessary, be sure to use genuine DOOSAN
CORPORATION INDUSTRIAL VEHICLE lift truck
parts. Lift trucks should never be operated without
an operational SEAT SWITCH SYSTEM.
To Next Page
Loading...
Need help?
General
