Operation Section
-82-
WARNING
When closing the engine hood, be careful not to
pinch your hand.
Circuit Breaker
Circuit Breaker - Protects the main
electrical circuits. To reset the circuit
breaker, push the button in. Located in the
engine compartment.
Seat
NOTE: Seat arrangements may vary.
Basic operation will be similar.
Seat adjustment should be checked at the
beginning of each shift and when operators
change.
Lock the seat into position before operating, to
prevent an unexpected seat change.
Adjust seat to allow full brake pedal travel with
operator’s back against seat back.
NOTE: The seat can only be correctly adjusted
with the operator fully seated.
Tilt Steering Column
To adjust the steering column, push down the
knob(1), and move the steering column to the
desired position, then release the knob(1).
Fuel Selector Switch (G424I(E)
/G424P(E) Dual Fuel Only)
1. LPG - This position supplies electrical
power to the LP fuel lock solenoid, when
the ignition switch is in the ON or the
START position.
With the LP fuel tank valve open, LP can then flow
the tank through the converter to the carburetor.
2. OFF – This position shuts off all fuel
supply to the carburetor/injector.
3. GAS - This position supplies electrical
power to gasoline fuel pump and injector.
This will allow gasoline fuel to flow from
the tank through the fuel filter and fuel
pump to the injector.
To Next Page
Loading...
Need help?
General
