ED800-9
Initially install screws for slots "A" as pictured, allowing 5/16" between the screw head and the frame.
Align the slots in the mounting plate with the screws. Slide the mounting plate over the screw and hold
the unit in place until the balance of the screws are installed. Tighten all screws securely.
08102710 05/07
Remove two (2) cover screws and cover. Disconnect cover ground wire at base plate. Loosen,
but do not remove end cap screws and slide end caps off.
Note:
Re-install end caps, cover ground wire and cover after installation is complete. Push-in emblems
or logo decals can be applied to hide cover screws if needed.
END CAP
SCREW
GROUND WIRE FOR COVER
END CAP
WITH
SWITCHES
END CAP
COVER
SLOT "A"
SLOT "A"
HINGE SIDE OF DOOR
(LEFT HAND MOUNT SHOWN)
To Next Page
Loading...
