Dormakaba SVA 6 Series User Manual

5.6 Parameterization
The parameters are set from the inside of the door in
its installed state. The switches in the door lock are
operated with a door handle or key.
Symbol Operating method
To start parameterization or to
save changed parameters:
Turn the door key in the locking
cylinder in the unlocking direction
until it stops and hold it there for
at least 10s.
Symbol Operating method
To jump from one selection to the
next:
Turn the door key briefly in the
locking cylinder in the unlocking
direction until it stops.
To jump from setting to setting
within a selection:
Briefly press down the door handle
until it stops.
Fig. 27
*
*
Operation
mode
DCW®
address
CAN
address
Terminating
resistor
* only with SafeRoute components
Start End
Off
On
Flow chart
16
SVA door locks
2019-07
WN 059743 45532
dormakaba Mounting instructions Parameterization (SVA2000/2000F only)

Dormakaba SVA 6 Series Specifications

General

Brand	Dormakaba
Model	SVA 6 Series
Category	Door locks
Language	English