/ 31
Maintenance
WARNING: Before performing any work on the DOSATRON, you must
read to the Precautions section, page 15.
RECOMMENDATIONS
1.We recommend periodically dismantling the entire injection assembly (refer
to: Cleaning and refitting the suction valve, page 39, Replacing the injection
seals, page 36). Thoroughly rinse all elements of the injection assembly with
clear water and reassemble them, having previously greased the seal
(shown below) with a silicone-based lubricant.
2.Before restarting the DOSATRON at the start of the period of use, remove
the motor piston and soak it in lukewarm water (<40 °C) for a few hours. This
will remove any deposits that may have dried in the motor piston.
fig 25
To Next Page
Loading...
