/ 39
CLEANING AND REFITTING THE SUCTION VALVE
WARNING: Before performing any work on the DOSATRON, you must
read to the Precautions section, page 15.
NOTA: Before dismantling, and to avoid any contact with the injected
additives, turn on the DOSATRON and allow it to draw in clear water in order
to rinse the injection assembly.
• Turn off the water supply and allow the pressure to drop to zero.
• Remove the suction hose (see Dismantling the suction hose, page 33).
• Unscrew the suction valve locking nut.
• Release the suction valve by pulling it through the middle of the injection
assembly
• Thoroughly rinse the various parts of the valve using clear water.
• Reassemble the parts following the order and positions shown in the
diagram.
D3IL10
To Next Page
Loading...
