CALL TOLL FREE 1-800-DR-OWNER 31
Removing the Wheels
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE.
Tool Needed:
• (2) 7/16" wrench or socket
1. Block the machine so the Wheel to be removed is off the ground.
2. While holding the Shear Bolt Head (Figure 25) with one wrench, remove the Shear Bolt Nut with
the other wrench.
3. Remove the Shear Bolt and slide the Wheel off the axle (Figure 25).
4. Replace the Wheel in the reverse order as above.
NOTE: Do not over tighten the Shear Bolt Nut when reinstalling the Wheel.
Figure 25
Shear Bolt
Shear Bolt Nut
To Next Page
Loading...
