Dräger Primus User Manual

Preparation
Preparation
Use only cleaned and disinfected parts!
Connecting the gas supply
1
28
Screw the central gas supply pressure hoses for 02, AIR
and N20 into the ports of the gas supply block at the back
of the device. The two outer ports at the back are reserved
for the backup gas cylinders.
A compressed air outlet for the optional secretion
aspiration and an O2 outlet for an external O2 flow tube are
optionally available.
Plug the other end of the pressure hoses into the wall
supply points.
Ensure that the gas pressures at the workstation are
between 2.7 and 6.9 bar:
All three LEDs illuminate green.
The LEDs remain dark if the gas pressure is <2.7 bar
or if the gas hose is not connected.
TA ЕЛ
00
0
0
i O
1
N20 AIR 02 [o] ©
M
RE 8
iif i
Ordger Primus
U
U
eee 000
2
oo €
LIL LLLLLL G
U
L
uni
0007
Instructions for Use Primus SW 2.n

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup