Dräger Primus User Manual

Ventilation
Starting ventilation mode
e.g. pressure-controlled ventilation
1 Confirm via rotary knob.
@ Soft keys turn green.
The preset ventilation parameters are
displayed on the screen.
Fresh-gas flows, as indicated by the
rotating symbol » @ « in the soft key
»flow L/min«.
If a ventilation parameter has to be
changed:
© Press the soft key for the ventilation
parameter concerned, then set and
confirm the ventilation parameter via
the rotary knob.
Frequency changes
Depending on the configuration, the
inspiratory time TINSP can be
automatically changed together with
adjustment of the frequency in volume or
pressure-controlled ventilation without
synchronization, so that the resultant
ratio of inspiration to expiration |: E
remains constant, see page 113.
For dependent setting of the change in
TINSP:
© Press Frequency key, key lights up
yellow.
© Adjust the ventilation parameter
Frequency via the rotary knob and
press the rotary knob to confirm.
The value for the ventilation
parameter TINSP automatically turns
yellow and is adjusted at the same
time. The ratio of inspiration to
expiration |: E remains constant.
64
000 000000
SN
Pressure
44 Jun CR
15°08 10
uni,
0036
Instructions for Use Primus SW 2.n

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup