Dräger Primus User Manual

Presetting the ventilation mode
e.g. pressure-controlled ventilation
1 Press the soft key »Press. Mode«, its
LED and the status line flash.
@ The ventilation parameters valid for
this mode are displayed on the
screen against a grey background.
2 Soft keys grey = parameters are not
yet active
3 Press the soft key for the individual
ventilation
parameters and their
colour changes to yellow.
4 Set and confirm the ventilation
parameters via the rotary knob.
Display (example):
The system reverts to the last active
mode if there is no interaction by the
user within 15 seconds when pre-setting
the ventilation mode.
in this example, the system returns to
volume-controlled ventilation.
instructions for Use Primus SW 2.n
Ventilation
Primus
000 OOOO
1
ooo ooo
DO
000
Ос
14 Jun. 2003 +
Pressure
5
100
-:
63
uni
0035

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup