Dräger Primus User Manual

Connecting the power supply
The mains voltage must correspond to that specified on the
rating plate at the back of the workstation.
Voltage range: 85 to 264 V.
@ Plug the mains plug into the wall socket.
LED »« on the front of the workstation lights up green.
Fuses for supplementary socket outlets
When using the twofold socket strip with automatic circuit-
breakers:
If a fuse is tripped (position 0):
@ Remedy the fault, then
@ Press the switch on the automatic circuit-breaker into
position I. The fuse is now active again.
When using the three-fold socket strip* with safety fuses:
@ Remedy the fault, then
@ have the safety fuse replaced by an electrician.
Only available in countries with socket outlets conforming
to DIN 49440
Instructions for Use Primus SW 2.n
Preparation
uni_0012
000
OO
|
31
uni
ODA?

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup