Dräger Primus User Manual

Adjustment ranges and default values upon delivery
Ventilation parameters
Adjustment range Default value
upon delivery!)
[sec.]
Pressure limitation 10 to 70 40
PMAX [mbar] min. PEEP +10
Tidal volume VT [mL] 20 to 14002 600
Frequency Freq.) 3to 80 12
[1/min]
TINSP” [sec.] 0.2 to 6.7 1.7
Insp. pause time : O to 60 10
insp. time TIP : TINSP
[%]
PEEP [mbar] O to 20 0
max. PMAX - 10
Trigger sensitivity OFF, 3.0 (Press.
»Trigger« [L/min] 0.3 to 15 Supp. Mode)
OFF (Vol./
Press. Mode)
Pressure support OFF,
»APPS«®) [mbar] 3 to 50 5 (Press
Supp. Mode)
max. PMAX-PEEP
OFF (Vol./
Press. Mode)
Rise time «TSLOPE« 0.0 to 2.0 0.0
1) The default values can be set specifically for the hospital concerned,
see page 106.
2) Optionally 10 to 1400 mL.
3) Depending on the configuration, the inspiratory time TinsP can be
automatically changed together with adjustment of the frequency so
that the resultant ratio of inspiration to expiration E remains
constant. Only applies if trigger = OFF, see "Ventilator and gas
delivery" on page 113.
4) The resultant ratio of inspiration to expiration |: E is also displayed
in parallel.
5) Optional.
Instructions for Use Primus SW 2.n
Ventilation
57

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup