Dräger Primus - Page 60

Adjustment ranges and default values upon delivery
Ventilation parameters
Adjustment range
Default value
upon delivery!)
Pressure limitation 5 to 70 15
PINSP [mbar] min. PEEP +5
Frequency Freq.2)3) 3 to 80 12
[1/min]
Inspiratory time 0.2 to 6.7 1.7
TINSPŸ)
PEEP* [mbar] 0 to 20 0
max. PINSP —5
Trigger sensitivity OFF, 3,0 (Press.
Trigger [L/min] 0.3 to 15 Supp. Mode}
OFF (Vol./
Press. Mode)
Pressure support OFF,
APPS5) [mbar] 3to 50 5 (Press. Supp.
Mode)
max. PMAX-PEEP
OFF (Vol./
Press. Mode)
Rise time 0.0 to 2.0 0.0
TSLOPE [sec.]
1) The default values can be set specifically for the hospital concerned,
see page 106.
2) Depending on the configuration, the inspiratory time TinsP can be
automatically changed together with adjustment of the frequency so
that the resultant ratio of inspiration to expiration |: E remains
constant.
Only applies if trigger = OFF, see "Ventilator and gas delivery" on
page 113.
3) The resultant ratio of inspiration to expiration | : E is also displayed
in parallel.
4) Depending on the configuration, the pressure limit Pinsp can be
changed automatically together with adjustment of the PEEP value.
See "Starting ventilation mode" on page 64 and
"Ventilator and gas delivery" on page 113.
5) Optional.
60
Instructions for Use Primus SW 2.n