Dräger Primus User Manual

Changing patients
Changing patients
To switch Primus to standby:
@ Press the standby key Ol and
confirm with the rotary knob.
The functions of the workstation are
switched off.
The set patient age, weight, alarm limits,
gas delivery settings and ventilation
parameters are retained.
To activate the default settings:
© Press the soft key »restore default
settings« and confirm.
The default settings for gas delivery,
ventilation parameters and alarm limits
are restored.
Change soda lime
— If the soda lime in the absorber has
turned violet.
— Ifthe inspiratory CO2 concentration
is 5 mmHg or more.
© Press the standby key O) and
confirm via the rotary knob.
-A Slide the writing top inwards.
2 Press the release button” on the
ventilator unit and pull the unit out.
3 Turn the absorber anticlockwise and
pull it down and off.
@ Empty out the used soda lime and
dispose of it with domestic waste.
@ Fillthe absorber to the upper mark
with fresh soda lime.
© Fitthe absorber into the breathing
system from below and turn it
clockwise as far as it will go.
@ Push the breathing system inwards
until it clicks into place.
© Puli the writing table out.
not yet available
72
Primus
SW version 20
Last šelf test: 12 Jun. 00:30
Run the self test at least every 24 hours.
The davice is tested and ready for
Enter age and ideal body weight to adjust ventilator and alarm settings.
0020
uni_0042
uni
0043
Instructions for Use Primus SW 2.n

Dräger Primus Specifications

General

Type	Anesthesia Workstation
Oxygen Flush	Yes
Ventilation Modes	Pressure Support
Gas Supply	O2, Air, N2O
Vaporizers	Isoflurane, Sevoflurane, Halothane
Patient Monitoring	Airway Pressure
Backup Battery	Yes
Alarms	Apnea, Gas supply failure
Power Supply	AC Mains, Battery Backup