Dräger Primus - End of operation

Changing patients
End of operation
To switch Primus to standby:
@ Press the standby key ©), and
confirm via the rotary knob. The
workstation is now in standby.
The fresh-gas flow is switched off.
Manual ventilation is possible!
To switch Primus off:
© Push the power switch » MÖ Om «in
completely.
Primus has a power-down delay.
When the power switch is pressed, an
acoustic signal sounds and for 10 sec.
the following message is displayed:
»Please wait while Primus shuts down.
Make sure that the O2 safety control
valve is closed.«
During this time, Primus can be
restarted immediately by pressing the
power switch again.
@ Unplug the gas supply hoses from
the wall sockets.
@ Close the cylinder valves.
If the hoses remain connected to the
wall sockets, minute internal leaks
may lead to contamination of the
gases.
@ Leave Primus plugged into the power
supply in order to charge the
uninterruptible power supply UPS.
@ We strongly recommend switching
off the device once a day in order to
carry out the power-on self test.
Remove any water which may have
accumulated in the ventilator
diaphragm.
Larger quantities .of condensation
may impair operation of the
workstation and/or lead-to failure of
the eguipment.
Switch off the anaesthetic gas
scavenging system AGS:
© Disconnect the anaesthetic gas
scavenging hose.
74
Instructions for Use Primus SW 2.n
0032