Dräger Primus - Alarm displays; Suppressing alarm

Alarms
Alarm displays
Alarm messages are displayed in the
alarm field in order of priority. Up to
three messages can be displayed
simultaneously. In some cases, the
corresponding measured values are
highlighted on the screen by a flashing
background in addition to the alarm
message.
tf more than three alarms occur
simuitaneously, the symbol » $
appears to the right of the alarm field
and the soft key »all alarms« is activated
on the right-hand side of the screen.
When this soft key is pressed, the upper
curve display is replaced by up to six
additional alarm fields for 15 seconds.
The curve reappears when the soft key
»all alarms« is pressed again or when
the 15 seconds have expired.
Suppressing alarm
Some alarms can be temporarily
suppressed. This can be done
automatically depending on the
ventilation mode or manually in the menu
“Standby config.” or permanently via the
alarm menu
Disabled alarms are identified by the
symbol » jz « alongside the
corresponding parameter.
If only individual alarm limits have been
disabled for a monitored parameter, this
is indicated by the corresponding
symbol » X« or » Xx.
The series of alarm tones can be
suppressed for 2 minutes:
O Press the A) key, the yellow LED
lights up.
The symbol » À « appears in the system
information field, with an indication of
the time remaining until the alarm is
enabled {minutes:seconds).
To enable the alarm tone:
© Press the (4). key, the yellow LED
goes out.
96
Ea
9%
VENTILATOR
UNLOCKED
BATTERY
LOW
POWER
FAIL
14 Jun. 2003
15:05
Instructions for Use Primus SW 2.n
0047