What to do if Dräger X-am 5100 Security Sensors won't switch off?
If your Dräger Security Sensors won't switch off, it could be because the instrument is not set to measuring mode. Select measuring mode. Alternatively, the instrument might be configured to "Disable prohibited". Configure the instrument to "Disable allowed" with Dräger CC Vision.
What to do if Dräger X-am 5100 database is full?
If error code 154 appears, it indicates that the database is full. To resolve this, read the database and clear the memory.
What to do if Dräger X-am 5100 Security Sensors database is 90% full?
If error code 153 appears, it indicates that the database is 90% full. To resolve this, read the database soon and then clear the memory.
Why Dräger X-am 5100 display '– –'?
The display showing '– –' on your Dräger Security Sensors indicates that the measuring range may be calibrated incorrectly. Recalibrate the measuring range. If the issue persists, the electronics or sensors could be defective, requiring repair by DrägerService.
What to do if Dräger X-am 5100 bump test interval has elapsed?
If error code 155 appears, it indicates that the interval for the bump test has elapsed. Perform the bump test.
What to do if Dräger Security Sensors display error 304?
If error code 304 appears, it indicates that the Dräger Sensor XS EC1 is not inserted or is defective. Check DrägerSensor XS EC1.
What does error 301 mean on Dräger Security Sensors?
Error code 301 indicates no valid zero point adjustment of the Dräger Sensor XS EC1. Perform a fresh air calibration.
What does error 302 mean on Dräger X-am 5100?
Error code 302 indicates no valid sensitivity adjustment of the Dräger Sensor XS EC1. Perform sensitivity adjustment or fresh air adjustment.
How to fix error 305 on Dräger X-am 5100?
Error code 305 indicates an error during the bump test of Dräger Sensor XS EC1. Repeat the bump test. If necessary, adjust or replace the Dräger Sensor XS EC1.
What does error 159 mean on Dräger X-am 5100 Security Sensors?
Error 159 means adjustment is not possible because a message is preventing the function (e.g., sensors in warm-up phase). Identify the message code via the info menu and switch off the device, if necessary.
General| Measurement Range (H2S) | 0 - 100 ppm |
|---|---|
| Measurement Range (Ex) | 0 - 100 % LEL |
| Measurement Principle | Electrochemical (O2, CO, H2S), Catalytic (Ex) |
| Display | LCD |
| Resolution (O2) | 0.1 % vol |
| Resolution (CO) | 1 ppm |
| Resolution (H2S) | 0.1 ppm |
| Resolution (Ex) | 1 % LEL |
| Accuracy (Ex) | ± 5 % LEL |
| Gas Detection | O2, CO, H2S, Ex (combustible gases) |
| Operating Temperature | -20 to +50 °C |
| Operating Humidity | 10 - 95% RH (non-condensing) |
| Power Supply | Rechargeable Li-ion battery |
| Alarm | Visual, audible, and vibration alarms |
| Data Logger | Yes |
| Accuracy (CO) | ± 5 ppm |
| Certifications | ATEX, IECEx, UL |
| Measurement Range (O2) | 0 to 25 vol.% |
To Next Page
