EasyManua.ls Logo

Dräger X-am 5100 - 2 Description; Product Overview; Intended Use; Intended Operating Area and Operating Conditions

Dräger X-am 5100
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Description
Dräger X-am 5100 5
2 Description
2.1 Product overview
Special symbols:
2.2 Intended Use
Portable single gas detection instrument for the continuous
monitoring of the concentration of HCl, HF, H
2
O
2
or hydrazine
in the ambient air within the working area and in explosion-
hazard areas.
2.3 Intended operating area and operating
conditions
2.3.1 Hazardous areas classified by zones
This instrument is intended for use in hazardous areas
classified as Zone 0, Zone 1 or Zone 2, or in mines in which
there is a danger of firedamp, in a temperature range of -20 °C
to +50 °C, and in areas where gases of explosion groups IIA,
IIB or IIC and temperature class T3 or T4 (depending on
batteries and rechargeable battery) may be present.
In mines, the instrument may only be used in areas with a low
risk of mechanical influence.
1 Alarm LED 8 Fastening clip
2 Gas entry 9 Type plate
3 Display 10 Power pack
4 key 11 Charging contacts
5 key 12 Measured gas display
6 Buzzer 13 Measured gas display
7 IR interface 14 Special symbols
Fault message 1-button sensitivity
adjustment
Warning message Standard sensitivity
adjustment
Display peak value Password required
Show TWA Battery 100 % full
Show STEL Battery 2/3 full
Bump test mode Battery 1/3 full
Fresh air adjustment Battery empty
0
X-am 5100
HCl ppm
00133279.eps
1
1
2
3
45
12 13 14
6
1
7
8
9
10
11
0.0
OK

Other manuals for Dräger X-am 5100

Related product manuals