Dragino LLDS40 - Configuring LLDS40 Uplink Interval and Data Visualization; Adjusting the Uplink Interval; Displaying Data in DataCake IoT Server

2.4! Uplink Interval
The LLDS40 by default uplink the sensor data every 20 minutes. User can change this interval by AT
Command or LoRaWAN Downlink Command. See this link:!
Change Uplink Interval
(
/xwiki/bin/view
/Main/End%20Device%20AT%20Commands%20and%20Downlink%20Command
/#H4.1ChangeUplinkInterval
)
2.5! Show Data in DataCake IoT Server
DATACAKE
(
https://datacake.co/
)
provides a human friendly interface to show the sensor data, once we
have data in TTN, we can use
DATACAKE
(
https://datacake.co/
)
to connect to TTN and see the data in
DATACAKE. Below are the steps:
!
Step 1
: Be sure that your device is programmed and properly connected to the network at this
time.
Step 2
: To configure the Application to forward data to DATACAKE you will need to add integration.
To add the DATACAKE integration, perform the following steps: