Dragino LLDS40 - Setting the Transmit Interval Time; Configuring Interrupt Mode

•
!Commands special design for LLDS40
These commands only valid for LLDS40, as below:
4.1! Set Transmit Interval Time
Feature: Change LoRaWAN End Node Transmit Interval.
AT Command: AT+TDC
Downlink Command: 0x01
Format: Command Code (0x01) followed by 3 bytes time value.
If the downlink payload=0100003C, it means set the END Node's Transmit Interval to 0x00003C=60(S),
while type code is 01.
•
Example 1: Downlink Payload:!0100001E! !!!// Set Transmit Interval (TDC) = 30 seconds
•
Example 2: Downlink Payload:!0100003C! !!!// Set Transmit Interval (TDC) = 60 seconds
!
4.2! Set Interrupt Mode
Feature, Set Interrupt mode for GPIO_EXIT.
AT Command: AT+INTMOD